Can I connect remote wire to battery?

No, run the remote wire to the remote out on the back of the headunit. You can then install a switch on the remote wire to turn it on or off, but if you run it directly to the battery you will have problems because the amps will always be on, and you will kill your battery.

What can I hook my remote wire to?

Since the remote turn on wire is low current, it can be connected to almost any fused output terminal (such as the one for the radio itself) as long as it only powers up when the vehicle is on.

How do I connect my remote wire to my amp?

1:185:02What is an Amplifier Remote Turn-On Wire? - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo in this case. Youre just going to wire up color for color here youre going to go blue withMoreSo in this case. Youre just going to wire up color for color here youre going to go blue with white to blue with white its your simple just connection made for your patent for your amplifier. Turn

Can you run a remote wire from one amp to another?

Yes. You can splice the tip of the remote wire, just before you reach an amp, and tap 2 wires, one from each amp. Ive seen some people put a jumper wire from the remote terminal of one amp to the remote terminal of the 2nd amp. It works.

What color is the remote wire?

Wiring Harness Color StandardsWire ColorWire FunctionRedSwitch / AccessoryBlackGroundBlueAntenna RemoteBlue with White StripeAmplifier Remote Turn-on10 more rows•22 Apr 2011

Can you put red and yellow wires together?

Yellow shoudl be hot all the time, red should trigger on when the ignition is on. I would not wire the yellow and red together, it is a given youll leave the h.u. on and drain your battery.

What color is a remote wire?

Wiring Harness Color StandardsWire ColorWire FunctionRedSwitch / AccessoryBlackGroundBlueAntenna RemoteBlue with White StripeAmplifier Remote Turn-on10 more rows•22 Apr 2011

Do I need to hook up power antenna wire?

Yes, these two wires should be connected together. This is what allows the radio to retract the antenna when it isnt being used. Just because your wiring harness has a connection for this wire, it doesnt necessarily mean that your car has this kind of motorized antenna.

How many amps is a remote wire?

Well, HUs remote output is a fixed constant value(refer to the particular HUs operating manual), it can be used to turn on 3-4 amps without much problem.

Can you split a remote wire?

I STRoNGLY advise against splitting the remote wire. True, it merely acts as a switch to complete the circuit for the amp, but it is crucial. Get craft with a relay, or even easier, just run the remote from a 12+ line thats on always if the car is on but off when car is.

What color is the power antenna wire?

blue Ground wires are black, antenna wires are blue, and amplifier wires are blue with a white stripe.

Can I connect red and yellow wires together?

Yes it does, depending on the body style its either the brown/red or yellow/red in the gray plug, two over from the clip. Red should be going to power, and yellow to auxillary/key.

Where do I connect the yellow wire?

Yellow wires are used as switch legs to ceiling fans, structural lights, and outlets paired with light switches, while blue wires are usually used as travelers for three-or-four-way switches.

What is the yellow and red wire on a car stereo?

The red wire is for the 12 volt ignition, which can be attached to the stereo. The yellow wire is the 12 volt battery wire, which should also be attached to the stereo for power. The final wire, the black wire, is the ground wire. This wire, once attached to the stereo, will help ground it.

What color is the constant 12V wire?

yellow Constant (yellow), also called BAT or Battery, provides permanent +12V power from battery.

What color is the memory wire?

When you find one that shows approximately 12V, you have found the constant 12V wire, also known as the memory wire. Its yellow in most aftermarket head units.

Where do you wire an amp to turn on?

The turn-on wire (also called the remote wire) is located behind the stereo. On aftermarket stereos, its usually a blue and white wire. The remote wire will tell your amplifier to turn on whenever the stereo is powered up (usually, whenever the vehicle is turned on).

How do I wire 3 amps?

5:2316:35How to Connect Multiple Amps And Wire Up A System - YouTubeYouTube

How do I turn on my amp without remote wire?

1:302:51How Can I Turn On My Amp Without Remote Wire? | Car Audio Q & AYouTube

How do you install a remote wire from a fuse box?

How To Wire Remote Wire For Amp To Fuse Box Key off the cars ignition to stop all the power going to the cars electrics to stop anything going wrong during working on the vehicle. Remove the radio fuse from the box. Wrap the remote wire around one metal pin of the fuse at the top part.More items •31 May 2016