Yes, its possible to use a car amplifier in your house. You can also connect a car amp to any home stereo, your smartphone, and more as an audio source. There is a catch, though. Because car amps use a different power source than home stereos the biggest problem is getting them the power they need.

Can car stereo be used at home?

You need a 12V power cord to use your car stereo power supply for home use, but you can easily get that from a hardware store. Cut the end of the power cord and connect the black wire with the line of white around the stereos red and yellow wires. Make sure every wire is completely covered before you plug it in.

How do you hook up an amp to a home stereo?

Hook up a home stereo to an amp with standard audio cables .Standard stereo audio cables complete the connection.Unplug the stereo and the amplifier from the electricity.Connect the two plugs on one end of the audio cable to the left and right output jacks labeled for the tape deck on the home stereo.More items

Can I use car woofer at home?

For the daring do-it-yourselfer, its completely possible to utilize the audio subwoofer of your car in your house. The most vital thing you need to be cautious of is electrical requirements as the car subwoofer is engineered to operate on a significantly lower current than what your home appliances operate on.

How do you hook up a car amplifier?

Your Step-By-Step GuideStep 1: Disconnect the Car Battery. Step 2: Mount the Amp. Step 3: Install the Power Wire. Step 4: Install the Fuse Holder. Step 5: Connect the Power Wire. Step 6: Install the Ground Wire. Step 7: Plug in RCA, Speaker, and Remote Turn-On Leads. Step 8: Turn It On.

What is the 12V accessory wire on a car stereo?

The wire that shows less than 12V at that point is the dimmer/illumination wire. Its typically orange or orange with a white stripe. The wire that still shows 12V is the accessory wire, which is usually red in aftermarket wiring harnesses. If only one wire ever had power in this step, it is the accessory wire.

Which woofer is best for home?

Below are the top 12 home theater subwoofers of 2021, check them out and go for the one you like most.Klipsch R-120SW. Polk HTS Home Theater Subwoofer. MartinLogan Dynamo Subwoofer. BIC America F12. Definitive Technology ProSub 1000. Audioengine S8. Bic Acoustech PL-200 II. SVS SB-1000.More items

Can I put any subwoofer in my car?

And its actually quite easy, thanks to simple subwoofer upgrades from the aftermarket that can be added to almost any existing car stereo system. Adding a subwoofer to your audio system generally means also having to purchase and install an amplifier to power it.

What should I set my low pass filter to?

As a general rule, the Low-Pass Filter should be set at a value approximately equal to (or below) 70% of your main speakers lowest frequency response. For example, your speakers frequency response goes down to 43Hz. 70% of 43Hz equals 30.1, so you should set the subwoofers low pass filter to 30Hz.

How can I test my car stereo without installing it?

6:307:39How to test a car radio without installing it at home - YouTubeYouTube

What is the accessory wire for on a car stereo?

Basically it tells the amp the stereo is on and it should turn on too. The accessory wire is what triggers the stereo to turn on when your ignition key is in the accessory position.

What is 12v trigger used for?

The 12 Volt Trigger is a powerful feature that comes equipped on all MSB powerbases and amplifiers. This simple 3.5mm mini-jack connection allows you to create a simple network between all of your MSB powerbases and amplifiers for a more seamless power up and standby experience.

Can you use stereo cable for 12v trigger?

You absolutely can use a stereo cable. Everything is the same except for the division between the ring and the sleeve on the stereo one. You arent going to short anything or reverse polarity or literally cause any issues by using a stereo cable. Trigger works now.